186
4-5. Using the driving support systems
LC500_LC500h_OM_OM11405U_(U)
■
Enabling/disabling the pre-colli-
sion system
The pre-collision system can be
enabled/disabled on (P.78) of
the multi-information display.
The system is automatically enabled each
time the engine switch <power switch> is
turned to IGNITION ON mode <ON
mode>.
If the system is disabled, the PCS warn-
ing light will turn on and a message will
be displayed on the multi-information
display.
■
Changing the pre-collision warn-
ing timing
The pre-collision warning timing can
be changed on (P.78) of the
multi-information display.
The operation timing setting is retained
when the engine switch
<power switch> is
turned off.
1 Far
The warning will begin to operate earlier
than with the default timing.
2 Middle
This is the default setting.
● When inspecting the vehicle using a
drum tester such as a chassis dyna-
mometer or speedometer tester, or
when using an on vehicle wheel bal-
ancer
●
When a strong impact is applied to the
front bumper or front grille, due to an
accident or other reasons
●
If the vehicle cannot be driven in a sta-
ble manner, such as when the vehicle
has been in an accident or is malfunc-
tioning
●
When the vehicle is driven in a sporty
manner or off-road
●
When the tires are not properly
inflated
●
When the tires are very worn
●
When tires of a size other than speci-
fied are installed
●
When tire chains are installed
●
When a compact spare tire or an
emergency tire puncture repair kit is
used
●
If equipment (snow plow, etc.) that may
obstruct the radar sensor or camera
sensor is temporarily installed to the
vehicle
Changing settings of the pre-col-
lision system
To Next Page
