331
7-2. Steps to take in an emergency
LC500_LC500h_OM_OM11405U_(U)
7
When trouble arises
vehicle, the towing eyelet must be
installed to your vehicle. Install the tow-
ing eyelet using the following proce-
dure.
1 Take out the towing eyelet.
(P.309)
2 Remove the eyelet cover using a
flathead screwdriver.
To protect the bodywork, place a rag
between the screwdriver and the vehicle
body as shown in the illustration.
3 Insert the towing eyelet into the
hole and tighten partially by hand.
4 Tighten down the towing eyelet
securely using a wheel nut wrench
or hard metal bar.
5 Securely attach cables or chains to
the towing eyelet.
Take care not to damage the vehicle body.
6 Enter the vehicle being towed and
start the engine <hybrid system>.
If the engine <hybrid system> does not
start, turn the eng
ine switch <power
switch> to IGNITION ON mode <ON
mode>.
7 Shift the shift position to N and
release the parking brake.
■
While towing
If the engine is not running <hybrid system is
off>, the power assist for the brakes and
steering will not function, making steering
and braking more difficult.
To Next Page
Loading...
