31
Brake Hold
To turn the system on, press the “HOLD” switch.
The brake hold standby indicator comes on.
While the system is holding the brake, the brake
hold operated indicator light comes on.
The system releases the brake when the acceler-
ator pedal is depressed with the shift lever in “D”
or “S” to allow smooth start off.
Turn Signa l Lever
Right turn signal
Left turn signal
To signal a lane change, move the lever partway
and then release it. The turn signals will flash 3
times.
The brake hold system keeps the brake applied when the shift lever is in “D”, “S” or “N”
with the system on and the brake pedal has been depressed to stop the vehicle.
To Next Page
Loading...
