177
3-3. Adjusting the seats
3
Operation of each component
LS600hL_U(OM50D26U)
Check that the shift lever is in P.
Turn the power switch to ON mode.
Adjust the driver’s seat, steering wheel, outside rear view mirrors and
seat belt shoulder anchor height to the desired positions. (When mem-
orizing the front passenger’s seat, adjust the front passenger’s seat to
the desired positions.)
Press the “SET” button, then
within 3 seconds press button “1”,
“2” or “3” until the signal beeps.
If the selected button has already
been preset, the previously recorded
position will be overwritten.
Driving position memory
Your preferred driving position (the position of the driver's seat and
steering wheel, angle of the outside rear view mirrors, and height of
seat belt shoulder anchor) can be memorized and recalled with the
touch of a button. It is also possible to set this function to activate auto-
matically when the doors are unlocked.
Three different driving positions can be entered into memory.
The same buttons are found on the front passenger's side, allowing the
front passenger's seat position and seat belt shoulder anchor height to
be memorized.
Entering a position to memory
1
2
3
4
To Next Page
Loading...
