COMFORT ADJUSTMENT
127
DRIVING POSITION MEMORY
SYSTEM
The micro computer can memorize the position of the driver’s seat,
and the positions of the tilt and telescopic steering, and outside rear
view mirrors. Two different driving position profiles can be entered
into the computer’s memory.
Recording a driving position in the computer’s memory can only be
done when the ignition key is in the ”ON” position and the shift lever
is in the ”P” position.
Setting a driving position
16X162
1. Adjust the driver’s seat , tilt and telescopic steering and
outside rear view mirrors to the desired position.
2. While pushing the ”SET” button, push button ”1” or ”2” until
the signal beeps.
The beep sound means that the positions are recorded in the
computer’s memory.
By repeating these two steps and pressing the remaining button, the
driving position for another driver can be recorded.
To set a new memorized position, select the desired position and
perform step 2. The previous memory will be erased and the new
position will be set.
To make only slight changes to an already memorized position, the
easiest way is to first activate the memorized position, then make the
desired changes and perform step 2 above.
Activating a memorized position
16X163
When you push button ”1” or ”2”, the driving position will be
automatically adjusted to the position recorded for that button.
To Next Page
Loading...
