IN CASE OF AN EMERGENCY
228
40X006a
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before raising the vehicle.
Turn the nuts counterclockwise to loosen them. To get maximum
leverage, fit the wrench to the nut so that the handle is on the right
side, as shown above. Grab the wrench near the end of the handle
and pull up on the handle. Be careful that the wrench does not slip
off the nut.
Do not remove the nuts yet − just unscrew them about one−half turn.
40X007d
5. Position the jack at the jack points as shown.
Make sure the jack is positioned on a level and solid surface.
JACK POINTS:
Front − Under the chassis frame side rail at the No.2 body mount
bracket
Rear − Under the rear axle housing
To Next Page
Loading...
