SWITCHES
25
WIPER AND WASHER SWITCH
12X004b
"
1
Interval adjuster
2
Washer on
To turn the wipers on, move the lever down until you reach the
desired speed setting.
The ignition key must be in the ”ON” position.
There are 3 settings:
”INT” position: Intermittent operation
”LO” position: Low speed operation
”HI” position: High speed operation
Twist the interval adjuster upward to increase the wiping time
interval between sweeps, and downward to decrease it.
The wiper lever must be in the ”INT” position.
To make the washer squirt, pull the lever toward you and release
it.
Even if the wiper lever is in the ”OFF” position, the wipers will
automatically operate a couple of times.
The low washer fluid warning light in the instrument cluster comes
on when the fluid level in the tank becomes nearly empty. For
information on adding washer fluid, see ”Adding washer fluid” on
page 294.
In cold weather, warm the windshield with the defroster before using
the washer. This will help prevent icing, which could block your
vision.
NOTICE
Do not operate the wipers if the windshield is dry. It may scratch
the glass.
To Next Page
Loading...
