INTERIOR EQUIPMENT
55
GARAGE DOOR OPENER
The garage door opener is manufactured under license from
HomeLink
R
and can be programmed to operate garage doors,
estate gates, security lighting, etc.
(a) Programming the garage door opener
14X041
"
1
Buttons
2
Indicator light
The garage door opener has 3 buttons and can be programmed
to operate 3 separate devices.
1. Decide which one of the 3 buttons you want to program. Push and
hold down the button until the indicator light begins to flash. While
holding this button, follow steps ”2” and ”3”.
2. Bring the hand held garage door opener within about 25mm (1
in.) of the button being programmed and push the button on the hand
held garage door opener. The signal from the hand held garage door
opener is sent to the vehicle’s opener.
3. When the frequency and code is registered, the indicator light
flashes rapidly. At this point, you can release both buttons.
4. To program the remaining buttons, repeat steps ”1” through ”3”.
If you want to write a new program over the program set already,
select a button you want to program and repeat the procedure from
step ”1”. The previous program is erased and a new program will be
set.
If the transmitter has a ”rolling code” feature, it is necessary to
program the in−garage receiver, after programming the garage
door opener in the vehicle. For setting the in−garage receiver,
refer to the instruction manual for the receiver.
After setting the in−garage receiver, push the programmed button on
the vehicle for about 1 to 2 seconds within the operational range.
Garage door openers manufactured before 1982 cannot be
programmed.
CAUTION
When programming or operating the garage door opener,
make sure there is no one around the moving door. It is
dangerous if someone is caught.
(b) Operating the garage door opener
Push the appropriate button to activate the garage door opener. The
indicator light comes on. The garage door opener continues to send
the signal for up to 20 seconds as long as the button is pushed.
To Next Page
Loading...
