314
3-1. Using the touch screen
LX570_U (OM60D99U)
The initial screen
If the “ENGINE START STOP” switch
is turned to ACCESSORY or IGNI-
TION ON mode, the initial screen will
be displayed for a few seconds as the
system starts up.
■ To avoid damaging the touch screen
● Touch the screen lightly with your finger. If there is no response, remove your fin-
ger from the screen and try again.
● Remove any dirt on the screen by wiping with a soft cloth. Do not use detergent.
■ When using the touch screen
● If the screen is cold, the display may be dark, or the system may seem to be
operating slightly slower than normal.
● The screen may seem dark and hard to see when viewed through sunglasses.
Change your angle of viewing, adjust the display on the “Display” screen or
remove your sunglasses.
To Next Page
Loading...
