35
1-2. Opening, closing and locking the doors
1
Before driving
LX570_U (OM60D99U)
■ Switching the door unlock function
If it is possible to set which doors the entry function unlocks using the wireless
remote control.
Turn the “ENGINE START STOP” switch OFF.
When the indicator on the key surface is turned off, press and hold
for approximately 5 seconds while pressing on the key.
The setting changes each time an operation is preformed, as shown below. (When
changing the setting continuously, release the buttons, wait for at least 5 seconds,
and repeat .)
Unlock the doors using the wireless remote control and open one of the
doors.
If a door is not opened within 60 seconds after is pressed, the doors will be
locked again and the alarm will automatically be set. In case that the alarm is trig-
gered, immediately stop the alarm. (P. 111)
STEP 1
STEP 2
STEP 2
Multi-information
display
Unlocking function Beep
Hold the driver’s door handle
to unlock only the driver’s
door.
Exterior: Beeps three
times
Interior: Rings once
Hold either door handle to
unlock all doors.
Exterior: Beeps twice
Interior: Rings once
STEP 3
To Next Page
Loading...
