49
1-2. Opening, closing and locking the doors
1
Before driving
LX570_U (OM60D99U)
Automatic door locking and unlocking systems
The following functions can be set or canceled:
■ Setting and canceling the functions
To switch between setting and canceling, follow the procedure below:
Close all the doors and switch the “ENGINE START STOP”
switch to IGNITION ON mode. (Perform step 2 within 20 sec-
onds.)
Shift the shift lever to “P” or “N”,
and press and hold the driver’s
door lock switch ( or ) for
approximately 5 seconds then
release.
The shift lever and switch positions corresponding to the desired function to be
set or canceled are shown as follows:
Function Operation
Shift position linked door
locking function
Shifting the shift lever out of “P” locks all doors.
Shift position linked door
unlocking function
Shifting the shift lever to “P” unlocks all doors.
Speed linked door locking
function
All doors are locked when the vehicle speed is
approximately 12 mph (20 km/h) or higher.
Driver’s door linked door
unlocking function
All doors are unlocked when the driver’s door is
opened within 10 seconds after turning the
“ENGINE START STOP” switch OFF.
STEP 1
STEP 2
To Next Page
Loading...
