DTC C1592/52 Actuator Neutral Position Calibration Incomplete
for Preparation Click here
DESCRIPTION
The steering control ECU first checks the actuator angle neutral position calibration flag after entering test mode. If the ECU detects that steering
actuator angle neutral position calibration is incomplete twice, it will store DTC C1592/52.
DTC Code DTC Detection Condition Trouble Area
C1592/52
The steering control ECU detects that steering actuator
angle neutral position calibration is incomplete twice.
Steering actuator
Steering control ECU
INSPECTION PROCEDURE
1.CLEAR DTC
a. Clear the DTCs (Click here).
NEXT
2.PERFORM VGRS SYSTEM CALIBRATION
a. Perform VGRS system calibration (Click here).
NEXT
3.CHECK DTC
a. Check for DTCs (Click here).
Result
Result
Proceed
to
C1592/52 is output after VGRS system calibration
has been performed 3 times or more
A
C15B2/72 is output (for LHD) B
C15B2/72 is output (for RHD) C
DTC is not output D
NOTICE:
If DTC C1592/52 is output even though the VGRS system calibration has been performed, confirm the procedure again, and perform the
VGRS system calibration 3 times or more.
B REPLACE STEERING CONTROL ECU (Click here)
C REPLACE STEERING CONTROL ECU (Click here)
D END
A
REPLACE STEERING ACTUATOR ASSEMBLY (Click here)
To Next Page
Loading...
