Lexus LX - Page 120

Standard Voltage:
Tester Connection Switch Condition
Specified
Condition
E11-1 (IG) - Body
ground
Engine switch on
(IG)
11 to 14 V
c. Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified
Condition
E11-2 (ESS) -
Body ground
Always Below 1 Ω
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
5.CHECK STEERING ANGLE SENSOR
a. Disconnect the E11 steering angle sensor connector.
b. Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection Switch Condition
Specified
Condition
E11-3 (BAT) -
E11-2 (ESS)
Engine switch on
(IG)
11 to 14 V
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE STEERING ANGLE SENSOR (Click here)