Standard steering effort:
Below 6.9 N*m (70 kgf*cm, 61 in.*lbf)
HINT:
After completing the inspection or repair, attempt to simulate the problem and then perform "Read Value Using Intelligent Tester" above
again to reconfirm that the problem does not occur.
NG
GO TO POWER STEERING SYSTEM (PROBLEM SYMPTOMS
TABLE) (Click here)
OK
4.CHECK STEERING ACTUATOR
a. Check for abnormal noise or vibration in the steering actuator.
OK:
Neither abnormal noise nor vibration occurs.
NG
GO TO STEERING WHEEL VIBRATES OR ABNORMAL NOISE IS
HEARD FROM STEERING WHEEL (Click here)
OK
5.CHECK STEERING CONTROL ECU (POWER SOURCE CIRCUIT)
a. Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection Switch Condition
Specified
Condition
E82-3 (IG) -
Body ground
Engine switch on
(IG)
11 to 14 V
E82-8 (PIG) -
Body ground
b. Turn the engine switch off.
c. Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified
Condition
E82-7 (PGND) -
Body ground
Always Below 1 Ω
Result
Result
Result
Proceed to
NG A
OK (for LHD) B
OK (for RHD) C
B REPLACE STEERING CONTROL ECU (Click here)
C REPLACE STEERING CONTROL ECU (Click here)
A
REPAIR OR REPLACE HARNESS OR CONNECTOR
To Next Page
Loading...
