Lexus LX - Steering Actuator Installation; Handling Precautions for Steering Actuator Assembly

STEERING ACTUATOR > INSTALLATION
for Preparation Click here
1. HANDLING PRECAUTIONS FOR STEERING ACTUATOR ASSEMBLY
NOTICE:
Be careful that the No. 2 seal lip or boot does not turn outward while carrying or installing the steering actuator assembly. If
installing a new steering actuator assembly, make sure that the spiral center lock pin is securely inserted.
Do not use the steering actuator assembly if it has been dropped.
2. INSTALL STEERING ACTUATOR ASSEMBLY
a. Make sure that the power steering link assembly is centered.
b. Install the steering actuator assembly.
i. If installing a new steering actuator assembly:
Install the steering actuator assembly with the white line on the upper
surface of the spiral case facing down.
NOTICE:
Do not pull out the center lock pin.
ii. If reinstalling the removed steering actuator assembly:
1. Slowly turn the spiral case clockwise until it locks.
2. Turn the spiral case two turns counterclockwise from the
lock position.
3. Align the slit of the sliding yoke with the alignment mark
(▲).
4. Install the steering actuator assembly with the white line
on the upper surface of the spiral case facing down.