STEERING CONTROL ECU (for LHD) > REMOVAL
for Preparation Click here
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
w/ Navigation System:
After the engine switch is turned off, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a
result, after turning the engine switch off, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
a. Detach the 8 claws.
b. Disconnect the connector and remove the panel pad.
3. REMOVE INNER NO. 1 INSTRUMENT PANEL BRACKET COVER LH
a. Detach the clip and remove the cover.
4. REMOVE INSTRUMENT SIDE PANEL LH
a. Place protective tape as shown in the illustration.
b. Using a moulding remover, detach the 6 claws and remove the side panel.
To Next Page
Loading...
