NOTICE:
When handling the airbag connector, take care not to damage the airbag wire
harness.
b. Install the driver side knee airbag with the 5 bolts.
Torque:
10 N*m{ 102 kgf*cm , 7 ft.*lbf }
5. INSTALL NO. 1 SWITCH HOLE BASE
a. Connect the connectors.
b. Attach the 5 claws to install the switch hole base.
6. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
a. Connect the connectors.
b. Attach the 2 claws to install the sensor.
c. Attach the 2 claws to connect the 2 control cables.
d. Attach the 16 claws to install the finish panel.
To Next Page
Loading...
