Lexus LX - Page 257

STEERING CONTROL ECU (for RHD) > INSTALLATION
for Preparation Click here
1. INSTALL STEERING CONTROL ECU
a. Install the steering control ECU to the junction block with the 2 bolts.
Torque:
for bolt A:
5.0 N*m{ 56 kgf*cm , 49 in.*lbf }
for bolt B:
8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
2. INSTALL STEERING CONTROL ECU WITH JUNCTION BLOCK
a. Front side:
Connect the 3 connectors.
b. Rear side:
i. Install the steering control ECU with junction block with the bolt and 2
nuts.
Torque:
8.0 N*m{ 82 kgf*cm , 71 in.*lbf }
ii. Connect the 2 connectors.