B/B Communication state of optional after parts ECU signal/OK or
Interruption
Interruption: Communication
interrupted
-
The Number of
DTCs
Number of diagnostic trouble codes/min.: 0, max.: 255
Actual number of diagnostic trouble
codes
-
PERFORM ACTIVE TEST
HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This
non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing
Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
a. Connect the intelligent tester to the DLC3.
b. Turn the engine switch on (IG).
c. Turn the intelligent tester on.
d. Enter the following menus: Body Electrical / Tilt & Telescopic / Active Test.
e. Check the values by referring to the table below.
Tilt & Telescopic
Tester Display Test Part Control Range Diagnostic Note
Tilt Operation Tilt operation Up/Down -
Telesco Operation Telescopic operation Long/Short -
To Next Page
Loading...
