DTC B2611 Telescopic Position Sensor or Telescopic Motor Circuit Malfunction
for Preparation Click here
DESCRIPTION
The telescopic motor is operated by the power source voltage supplied from the multiplex tilt and telescopic ECU and slides the steering column forward
and backward. The telescopic position sensor (Hall IC) in the telescopic motor detects the sliding position in the forward and backward directions of the
steering column and outputs a signal to the multiplex tilt and telescopic ECU based on that sliding amount.
HINT:
Limit positions can be confirmed on the screen of the intelligent tester.
DTC Code Detection Condition Trouble Area
B2611
The telescopic operation stops within the operation range
while operating.
Harness or connector
Telescopic position sensor or telescopic
motor
Multiplex tilt and telescopic ECU
WIRING DIAGRAM
To Next Page
Loading...
