NG REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
6.CHECK HARNESS AND CONNECTOR (ECU - BODY GROUND)
a. Disconnect the E27 multiplex tilt and telescopic ECU connector.
b. Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified
Condition
E27-11 (GND) - Body
ground
Always Below 1 Ω
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE MULTIPLEX TILT AND TELESCOPIC ECU ( Click here)
To Next Page
Loading...
