POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM > Actuator Power Source Circuit
for Preparation Click here
DESCRIPTION
This is the power source for the motors.
WIRING DIAGRAM
INSPECTION PROCEDURE
1.INSPECT FUSE (TI&TE)
a. Remove the TI&TE fuse from the main body ECU.
b. Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified
Condition
TI&TE fuse Always Below 1 Ω
NG REPLACE FUSE
OK
2.CHECK HARNESS AND CONNECTOR (MULTIPLEX TILT AND TELESCOPIC ECU - BATTERY)
a. Disconnect the E27 multiplex tilt and telescopic ECU connector.
b. Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection Condition
Specified
Condition
E27-2 (+B) - Body
ground
Always 11 to 14 V
To Next Page
Loading...
