STEERING LOCK SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING
for Preparation Click here
HINT:
Use the following procedures to troubleshoot the steering lock system.
*: Use the intelligent tester.
1.VEHICLE BROUGHT TO WORKSHOP
NEXT
2.INSPECT BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
NEXT
3.CHECK DTC*
a. Check for DTC (Click here).
Result
Result Proceed to
DTC is output A
DTC is not output B
A. Go to step 6
B
4.PROBLEM SYMPTOMS TABLE
Result
Result Proceed to
Fault is not listed in problem symptoms table A
Fault is listed in problem symptoms table B
B. Go to step 6
A
5.OVERALL ANALYSIS AND TROUBLESHOOTING*
a. Terminals of ECU (Click here).
b. Data List / Active Test (Click here).
NEXT
To Next Page
Loading...
