STEERING LOCK SYSTEM > DIAGNOSIS SYSTEM
for Preparation Click here
DESCRIPTION
a. When troubleshooting a vehicle with a diagnosis system, connect the intelligent tester to the DLC3 of the vehicle and read various data
output from the steering lock ECU.
The steering lock ECU stores DTCs when the ECU detects a malfunction in itself or in its circuits.
b. The diagnosis information of the steering lock ECU is transmitted to the intelligent tester via the certification ECU (smart key ECU assembly)
as the steering lock ECU is not connected to the CAN communication system.
c. The steering lock ECU does not store DTCs regarding past problems.
HINT:
When the engine switch is off, the main body ECU to which the intelligent tester is to be connected may be malfunctioning or in sleep
mode.
Communication with the intelligent tester is not possible if the main body ECU is not working.
d. As the steering lock ECU memory data will be cleared, do not remove the fuses or disconnect the battery terminals until the DTCs are
checked and noted.
e. Malfunctions related to systems other than the steering lock ECU system may cause DTCs to be output. Note any DTCs related to other
systems.
To Next Page
Loading...
