2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - MAIN BODY ECU)
a. Disconnect the E26 steering lock ECU connector.
b. Disconnect the E1 main body ECU connector.
c. Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified
Condition
E26-4 (SLP1) - E1-
18 (SLP)
Always Below 1 Ω
E26-4 (SLP1) or
E1-18 (SLP) -
Body ground
Always 10 kΩ or higher
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
OK
REPLACE STEERING LOCK ACTUATOR (STEERING LOCK ECU) ( Click here)
To Next Page
Loading...
