iii. Remove the RH and LH boot clips from the rack boots.
iv. Loosen the RH and LH lock nuts.
v. Turn the RH and LH rack ends by the same amount (but in different
directions) according to the steering angle.
HINT:
One 360° turn of the rack end (1.5 mm (0.0591 in.) horizontal
movement) equals 11° of steering angle.
vi. Tighten the RH and LH lock nuts to the specified torque.
Torque:
82 N*m{ 836 kgf*cm , 60 ft.*lbf }
NOTICE:
Make sure that the difference in length between the RH and LH tie rod ends and rack end screws is within 1.5 mm (0.0591 in.).
vii. Install the RH and LH boot clips.
To Next Page
Loading...
