STEERING COLUMN ASSEMBLY > ON-VEHICLE INSPECTION
for Preparation Click here
1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
a. Disable the Autoaway/Return function by changing the customize parameter ( Click here).
CAUTION:
Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the
current setting after finishing the operation.
HINT:
Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.
b. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
c. Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various
types of memory and settings. As a result, after turning the engine switch off, wait 6 minutes or more before
disconnecting the cable from the negative (-) battery terminal.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected ( Click here).
2. REMOVE LOWER STEERING COLUMN COVER
a. Remove the 3 screws.
HINT:
Turn the steering wheel to the right and left as necessary to remove the 2
screws.
b. Detach the 2 claws to remove the lower steering column cover.
To Next Page
Loading...
