Lexus LX - Page 430

STEERING COLUMN ASSEMBLY > REMOVAL
for Preparation Click here
CAUTION:
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing
the steering column (Click here).
1. FRONT WHEELS FACING STRAIGHT AHEAD
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
a. Disable the Autoaway/Return function by changing the customize parameter ( Click here).
NOTICE:
Record the current customize parameter setting (whether the AUTO TILT AWAY function is enabled or disabled) in order to restore the
current setting after finishing the operation.
HINT:
Performing the above operation causes the AUTO TILT AWAY function to be disabled when the engine switch is turned off.
b. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column assembly.
c. Turn the engine switch off and disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
NOTICE:
w/ Navigation System:
After the engine switch is turned off, the HDD navigation system requires approximately 6 minutes to record various types of memory and
settings. As a result, after turning the engine switch off, wait 6 minutes or more before disconnecting the cable from the negative (-) battery
terminal.
3. REMOVE LOWER NO. 3 STEERING WHEEL COVER
a. Detach the 2 claws and remove the steering wheel cover.
4. REMOVE LOWER NO. 2 STEERING WHEEL COVER
a. Detach the 2 claws and remove the steering wheel cover.