d. Put matchmarks on the steering actuator and No. 2 steering intermediate shaft.
e. Remove the bolt, and then pull out the actuator assembly toward the inside of
the vehicle.
28. REMOVE STEERING COLUMN HOLE COVER SUB-ASSEMBLY
a. Remove the 4 bolts, nut and steering column hole cover.
29. DISCONNECT NO. 2 STEERING INTERMEDIATE SHAFT
a. Loosen the bolt and remove the No. 2 intermediate shaft.
HINT:
If the dust cover is removed/installed or replaced, place matchmarks on the
dust cover and steering link.
NOTICE:
It is possible to install the intermediate shaft to the same position it was
To Next Page
Loading...
