STEERING WHEEL > INSTALLATION
for Preparation Click here
1. INSTALL STEERING WHEEL ASSEMBLY
a. Align the matchmarks on the steering wheel assembly and steering main shaft
assembly.
b. Install the steering wheel assembly set nut.
Torque:
50 N*m{ 510 kgf*cm , 37 ft.*lbf }
2. INSTALL STEERING PAD
a. Support the steering pad with one hand.
b. Connect the 2 connectors to the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire
harness.
c. Connect the horn connector.
d. Confirm that the circumference groove of the "TORX" screw fits in the screw
case, and place the steering pad onto the steering wheel.
e. Using a T30 "TORX" socket wrench, tighten the 2 screws.
Torque:
8.8 N*m{ 90 kgf*cm , 78 in.*lbf }
3. INSTALL LOWER NO. 2 STEERING WHEEL COVER
a. Attach the 2 claws to install the cover.
4. INSTALL LOWER NO. 3 STEERING WHEEL COVER
To Next Page
Loading...
