MULTIPLEX TILT AND TELESCOPIC ECU > REMOVAL
for Preparation Click here
1. REMOVE STEERING COLUMN ASSEMBLY
HINT:
Refer to the instructions for removal of the steering column assembly ( Click here).
2. REMOVE STEERING LOCK ACTUATOR ASSEMBLY
a. Using a center punch, mark the center of the 2 tapered-head bolts.
b. Using a 3 to 4 mm (0.118 to 0.157 in.) drill, drill a hole in the 2 bolts.
c. Using a screw extractor, remove the 2 bolts and the steering lock actuator
assembly from the steering column assembly.
3. REMOVE MULTIPLEX TILT AND TELESCOPIC ECU
a. Disconnect the 2 connectors.
b. Remove the 2 screws and ECU.
To Next Page
Loading...
