MULTIPLEX TILT AND TELESCOPIC ECU > INSTALLATION
for Preparation Click here
1. INSTALL MULTIPLEX TILT AND TELESCOPIC ECU
a. Install the ECU with the 2 screws.
Torque:
1.5 N*m{ 15 kgf*cm , 13 in.*lbf }
b. Connect the 2 connectors.
NOTICE:
The connectors on both ends of the wire harness between the telescopic
motor and ECU are the same shape. When installing them, connect the
connectors of the same color.
2. INSTALL STEERING LOCK ACTUATOR ASSEMBLY
a. Temporarily install the steering lock actuator assembly with 2 new tapered-head
bolts.
b. Tighten the 2 tapered-head bolts until the bolt heads break off.
3. INSTALL STEERING COLUMN ASSEMBLY
HINT:
Refer to the instructions for installation of the steering column assembly ( Click here).
To Next Page
Loading...
