the screw circumference catches on the screw case.
b. Pull out the steering pad from the steering wheel, as shown in the illustration.
Then support the steering pad with one hand.
NOTICE:
When removing the steering pad, do not pull the airbag wire harness.
c. Disconnect the horn connector.
d. Disconnect the 2 connectors and remove the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire
harness.
5. REMOVE STEERING WHEEL HEATER CONTROL ASSEMBLY
a. Disconnect the 2 connectors.
b. Remove the 2 screws and controller.
To Next Page
Loading...
