Lexus LX - Page 519

HEATED STEERING WHEEL CONTROLLER > INSTALLATION
for Preparation Click here
1. INSTALL STEERING WHEEL HEATER CONTROL ASSEMBLY
a. Install the controller with the 2 screws.
b. Connect the 2 connectors.
2. INSTALL STEERING PAD ASSEMBLY
a. Support the steering pad with one hand.
b. Connect the 2 connectors to the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire
harness.
c. Connect the horn connector.
d. Confirm that the circumference groove of the "TORX" screw fits in the screw
case, and place the steering pad onto the steering wheel.
e. Using a T30 "TORX" socket wrench, tighten the 2 screws.
Torque:
8.8 N*m{ 90 kgf*cm , 78 in.*lbf }
3. INSTALL NO. 2 STEERING WHEEL LOWER COVER
a. Attach the 2 claws to install the cover.
4. INSTALL NO. 3 STEERING WHEEL LOWER COVER
a. Attach the 2 claws to install the cover.