b. With the engine stopped, check the fluid level in the reservoir.
If necessary, add fluid.
Fluid:
ATF DEXRON II or III
HINT:
If the fluid is hot, check that the fluid level is within the HOT range. If the fluid
is cold, check that the fluid level is within the COLD range.
c. Start the engine and idle it.
d. Turn the steering wheel from lock to lock several times to raise the fluid
temperature.
Fluid temperature:
80°C (176°F)
e. Check for foaming or emulsification.
If foaming or emulsification is identified, bleed the power steering system.
f. With the engine idling, measure the fluid level in the reservoir.
g. Stop the engine.
h. Wait a few minutes and remeasure the fluid level in the reservoir.
Maximum fluid level rise:
5.0 mm (0.197 in.)
If the fluid level rise is more than the maximum, bleed the power steering
system.
i. Check the fluid level.
21. CHECK FOR POWER STEERING FLUID LEAK
22. INSTALL FRONT WHEELS
23. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
HINT:
Perform this procedure with the front of the vehicle jacked up.
24. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
a. Perform the vehicle height offset calibration (Click here).
25. ADJUST FRONT WHEEL ALIGNMENT
To Next Page
Loading...
