CLEAR DTC (Using SST Check Wire)
a. Turn the engine switch on (IG).
b. Using SST check wire, connect and disconnect terminals 13 (TC) and 4 (CG) of
the DLC3 4 times within 8 seconds.
SST
09843-18040
c. Disconnect SST check wire from the DLC3.
NOTICE:
As the stored yaw rate and G sensor value will be cleared by the above
operation, it is necessary to obtain the yaw rate and G sensor zero point.
d. Turn the engine switch off.
HINT:
If the problem still exists, DTCs may not be cleared.
e. Obtain the yaw rate and G sensor zero point ( Click here).
To Next Page
Loading...
