163
2-5. Driving information
2
When driving
Connecting trailer lights
Use the wire harness stored in the rear end under body.
■ When connecting and disconnecting a trailer
Connecting
Set the active height control suspension to “LO” mode.
Turn off the ignition switch or the active height control suspension.
Connect the trailer.
Turn on the switch that was turned off on step 2.
Set the active height control suspension to “N” mode.
Disconnecting
Set the active height control suspension to “LO” mode.
Turn off the ignition switch or the active height control suspension.
Set the supporting leg of the trailer on the ground and raise the hitch by 4
in. (100 mm).
Turn on the switch that was turned off on step 2.
Wait until vehicle height is stabilized.
Make sure the hitch is disconnected. If the hitch does not disconnect, raise
the hitch higher and repeat steps 2 through 5.
Move the vehicle forward in the “LO” mode to a point where the hitch
does not touch anything in the “N” mode.
Set the active height control suspension in the “N” mode.
STEP 1
STEP 1
STEP 2
STEP 1
STEP 3STEP 3
STEP 1
STEP 4STEP 4
STEP 5STEP 5
STEP 1
STEP 1
STEP 2
STEP 2
STEP 1
STEP 3STEP 3
STEP 1
STEP 4STEP 4
STEP 1
STEP 1
STEP 5STEP 6STEP 6
STEP 1
STEP 5STEP 6STEP 7STEP 7
STEP 1
To Next Page
