Lexus LX570 - Page 122

122
4. SETUP
LX570_Navi_OM60K73U_(U)
12.10.31 14:29
4 Touch either or to adjust the di-
rection of the current position mark.
5 Touch “OK”.
 The map will be displayed.
■ TIRE CHANGE CALIBRATION
1 To perform the distance calibration pro-
cedure, touch “Tire Change”.
 The message appears and the quick dis-
tance calibration is automatically started. A
few seconds later, a map will be displayed.
1 Press the “SETUP” button.
2 Touch “Navigation” on the “Setup”
screen.
3 Touch “Detailed Navi. Settings” on the
“Navigation Settings” screen.
4 Touch “Pop-up Information”.
5 Touch “On” or “Off”.
6 Touch “Save”.
 When “Pop-up Information” is turned off,
the following messages will not be dis-
played.
The tire change calibration function will
be used when replacing the tires. This
function will adjust miscalculation
caused by the circumference difference
between the old and new tires.
INFORMATION
●If this procedure is not performed when
the tires are replaced, the current posi-
tion mark may be incorrectly displayed.
POP-UP INFORMATION
When “Pop-up information” is turned
on, pop-up information will be displayed.