Lexus LX600 2024 - Rolling Code and 2-Way Communication

81
LX600_QG_OM60V82U_(U)
3 Program a device.
 Programming a device other than an entry gate (for U.S.A. owners)
Press and hold the remote control transmitter button until the HomeLink
®
indicator light
changes from slowly flashing orange to rapidly flashing green (rolling code) or continuously
lit green (fixed code), then release the button.
 Programming an entry gate (for U.S.A. owners)/Programming a device in the Cana-
dian market
Press and release the remote control transmitter button at 2 second intervals, repeatedly,
until the HomeLink
®
indicator light changes from slowly flashing (orange) to rapidly flashing
(green) (rolling code) or continuously lit (green) (fixed code).
4 Test the HomeLink
®
operation by pressing the newly programmed button and observ-
ing the indicator light:
● HomeLink
®
indicator light illuminates: Programming of a fixed code device has
completed. The garage door or other device should operate when a HomeLink
®
button is pressed and released.
● HomeLink
®
indicator light flashes rapidly: The garage door opener motor or other
device is equipped with a rolling code. To complete programming, firmly press and
hold the HomeLink
®
button for 2 seconds then release it.
● If the garage door or other device does not operate, proceed to “Programming a
rolling code system”.
5 Repeat the steps above to program another device for any of the remaining
HomeLink
®
buttons.
 Vehicles with inside rear view mirror  Vehicles with Digital Rear-view Mirror