94
LX600_QG_OM60V82U_(U)
■ Opening/closing the back door using the kick sensor (vehicles with Hands
Free Power Back Door)
The Hands Free Power Back Door enables automatic opening and closing of the power
back door by putting your foot near the right lower part of the rear bumper and moving it
away from the rear bumper. When operating the Hands Free Power Back Door, make sure
that all of the following conditions are met.
• The engine switch is in OFF, or ON with the shift lever in P.
• The kick sensor operation is enabled.
• You are carrying an electronic key.
1 While carrying an electronic key, stand within the smart access system with push-but-
ton start operation range, approximately 11.8 to 19.7 in. (30 to 50 cm) from the rear
bumper.
Kick sensor
Hands Free Power Back Door opera-
tion detection area
Smart access system with pushbutton
start operation detection area
2 Perform a kick operation by moving your foot to within approximately 3.9 in. (10 cm) of
the rear bumper, and then pulling your foot back after the buzzer sounds.
Kick sensor
Hands Free Power Back Door opera-
tion detection area
3 When the kick sensor detects that your foot is pulled back, a buzzer will sound and the
back door will automatically fully open/close.
A
B
C
A
B
To Next Page
Loading...
