109
3-2. Opening, closing and locking the doors
3
Before driving
To prevent unintended triggering of the
alarm, unlock the doors using the wireless
remote control and open and close a door
once after the settings have been changed.
(If a door is not opened within 30 seconds
after is pressed, the doors will be
locked again and the alarm will automati-
cally be set.)
In case that the alarm is triggered, immedi-
ately stop the alarm. (P.73)
■ Impact detection door lock release sys-
tem
In the event that the vehicle is subject to a
strong impact, all the doors are unlocked.
Depending on the force of the impact or the
type of accident, however, the system may
not operate.
■ Operation signals
Doors: A buzzer sounds and the emer-
gency flashers flash to indicate that the
doors have been locked/unlocked
(Locked: Once; Unlocked: Twice)
Windows and moon roof: A buzzer sounds
to indicate that the windows and moon roof
are operating.
■ Security feature
If a door is not opened within approximately
60 seconds after the vehicle is unlocked,
the security feature automatically locks the
vehicle again. (However, depending on the
location of the electronic key, the key may
be detected as being in the vehicle. In this
case, vehicle may be unlocked.)
■ When the door cannot be locked by the
lock sensor on the upper part of the
door handle
If the door will not lock even when the top-
side sensor area is touched, try touching
both the topside and underside sensor
areas at the same time.
When gloves are being worn, remove the
gloves.
■ Door lock buzzer
If an attempt to lock the doors using the
entry function is made when a door other
than the door you are locking is open, a
buzzer sounds continuously for 5 seconds.
Fully close all the doors, and lock the vehi-
cle once more.
■ Setting the alarm
Locking the doors will set the alarm system.
(P.73)
■ Conditions affecting the operation of
the smart access system with push-but-
ton start or wireless remote control
P.129
■ If the smart access system with push-
button start or the wireless remote con-
trol does not operate properly
● Use the mechanical key to lock and
unlock the doors. (P.644)
● Replace the battery with a new one if it is
depleted. (P.595)
■ If the 12-volt battery is discharged
The doors cannot be locked and unlocked
using the smart access system with push-
button start or wireless remote control.
Lock or unlock the doors using the
mechanical key. (P.644)
Multi-information
display/Beep
Unlocking function
Exterior: Beeps 3
times
Holding the driver’s
door handle unlocks
only the driver’s door.
Holding a passen-
ger’s door handle
unlocks all the doors.
Exterior: Beeps twice
Holding a door han-
dle unlocks all the
doors.
To Next Page
Loading...
