128
3-2. Opening, closing and locking the doors
with Advanced Park remote control
function)
■ Effective range (areas within which the
electronic key is detected)
When locking or unlocking the doors
The system can be operated when the elec-
tronic key is within about 2.3 ft. (0.7 m) of
the front door handles, rear door handles
and back door opener switch. (Only the
doors detecting the key can be operated.)
When starting the hybrid system or
changing power switch modes
The system can be operated when the elec-
tronic key is inside the vehicle.
■ If an alarm sounds or a warning message
is displayed
An alarm sounds and warning message dis-
plays shown on the multi-information dis-
play are used to protect against
unexpected accidents or theft of the vehicle
resulting from erroneous operation. When
a warning message is displayed, take
appropriate measures based on the dis-
played message.
When only an alarm sounds, circumstances
and correction procedures are as follows.
● When an exterior alarm sounds once for
5 seconds
● When an interior alarm pings continu-
ously
■ Battery-saving function
The battery-saving function will be acti-
vated in order to prevent the electronic key
battery and the 12-volt battery from being
discharged while the vehicle is not in opera-
tion for a long time.
● In the following situations, the smart
access system with push-button start may
take some time to unlock the doors. Also
the illuminated entry system may not
operate properly.
• The electronic key has been left near of
the vehicle for a certain period of time.
• The smart access system with push-but-
ton start has not been used for 5 days or
longer.
● If the smart access system with push-but-
ton start has not been used for 14 days or
longer, the doors cannot be unlocked at
any doors except the driver’s door. In this
case, take hold of the driver’s door han-
dle, or use the wireless remote control or
the mechanical key, to unlock the doors.
■ Turning an electronic key to battery-
saving mode
● When battery-saving mode is set, battery
depletion is minimized by stopping the
electronic key from receiving radio
waves.
Press twice while pressing and
holding .
Confirm that the electronic key indicator
flashes 4 times.
Situation
Correction proce-
dure
An attempt was
made to lock the
vehicle while a door
was open.
Close all of the
doors and lock the
doors again.
B
Situation
Correction proce-
dure
The power switch
was turned to ACC
while the driver’s
door was open (or
the driver’s door was
opened while the
power switch was in
ACC).
Turn the power
switch to OFF and
close the driver’s
door.
To Next Page
Loading...
