225
4-3. Operating the lights and wipers
4
Driving
lights or tail lights in the surrounding area
• When headlights or tail lights of vehicles
ahead are turned off, dirty, changing
color, or not aimed properly
• When the headlights are repeatedly
changing between the high beams and
low beams.
• When use of the high beams is inappro-
priate or when the high beams may be
flashing or dazzling pedestrians or other
drivers.
• When the vehicle is used in an area in
which vehicles travel on the opposite side
of the road of the country for which the
vehicle was designed, for example using
a vehicle designed for right-hand traffic in
a left-hand traffic area, or vice versa
• When it is necessary to disable the sys-
tem: P.239
• Situations in which the sensors may not
operate properly: P.244
■ Customization
The settings of some functions can be
changed. (P.677)
■ Changing to the high beams
1 Push the lever forward.
The AHS indicator will turn off and the high
beam indicator will turn on.
Pull the lever to its original position to
enable the Adaptive High-beam System
again.
■ Changing to the low beams
1 Press the Adaptive High-beam
System switch.
The AHS indicator will turn off.
Press the switch to enable the Adaptive
High-beam System again.
It is recommended to switch to the low
beams when use of the high beams is
inappropriate or when the high beams
may cause problems or distress to
other drivers or pedestrians nearby.
1 Pull the lever rearward and then
return it to its original position.
The high beams will illuminate while the
lever is pulled, however, after the lever is
returned to its original position, the low
beams will remain on for a certain amount
of time. After this, the Adaptive High-beam
System will operate.
Turning the high beams on/off
manually
Temporarily changing to the low
beams
To Next Page
Loading...
