444
4-5. Using the driving support systems
on the Front Multi Operation Panel.
When the easy access mode is in on, the
indicator on the switch and the easy
access mode indicator on the meter
comes on.
If the power switch is turned off within
approximately 30 seconds after the vehi-
cle is stopped while easy access mode is
on, the vehicle height is lowered automati-
cally.
When the vehicle begins to lower, a
buzzer will sound twice. The easy access
mode indicator display will come on while
the vehicle is lowering to indicate that the
vehicle is lowering.
When the operation is complete, the easy
access mode indicator will turns off.
■ Operation conditions of the easy access
mode
● The easy access mode is operational
when all of the following conditions are
met:
• The vehicle height mode is in N mode.
• The vehicle is stopped on a flat surface.
• The shift position is in P.
• The side doors and back door are not
opened after the vehicle is stopped.
● The following method will cancel the
vehicle lowering operation and raise the
vehicle again:
• Press the height select switch .
Press the height control OFF switch on
the Front Multi Operation Panel while
the vehicle is stopped.
The indicator on the switch will
come on and the OFF indicator will
display on the AHC display.
When the height control OFF indicator
is displayed, the vehicle height will not
change even if the height select switch
is operated.
Press the switch again to turn the sys-
tem back on.
■ Operating conditions of the AHC
● The hybrid system must be operating.
● Vehicle height control must be turned off.
● All side doors and the back door must be
closed.
■ Vehicle height control speed
The vehicle height control speed will
change depending on the operating state of
the AHC.
A
Disabling the height control
A
To Next Page
Loading...
