448
4-5. Using the driving support systems
H4 (high speed position)
Normal driving on all types of roads.
L4 (low speed position)
Driving requiring maximum power and
traction such as climbing or descending
steep hills, off-road driving, and hard pull-
ing in sand or mud, etc.
The low speed four-wheel drive indicator
will come on.
■ Shifting from H4 to L4
1 Stop the vehicle completely.
2 Shift the shift position to N.
3 Push and turn the four-wheel drive
control switch counterclockwise.
■ When parking in areas with limited
overhead height
After leaving the vehicle or unloading the
luggage, the vehicle height may be
slightly higher than normal. Take care
when overhead height is limited.
■ To avoid damage to the vehicle
● N mode will be switched to automati-
cally even if the vehicle is started off in
L mode. Take care when overhead
height is limited.
● Do not select L mode when driving on
bumpy roads, as the underbody of the
vehicle may contact the road surface.
● When traveling on bumpy roads or
through water, or when towing, turn off
easy access mode.
■ Avoid rapid changes to the vehicle
height
As the pump may overheat. Leave a few
seconds between selections when
changing the vehicle height mode.
Four-wheel drive system
Use the four-wheel drive control
switch and center differential lock
switch to select the following trans-
fer and center differential modes.
Four-wheel drive control switch
Shifting between H4 and L4
A
To Next Page
Loading...
