457
4-5. Using the driving support systems
4
Driving
place, and allow the brake system to cool
down sufficiently until the message goes
off. (In the meantime, normal driving is
possible.)
● If Crawl Control is used continuously for
a long time, the automatic transmission
may overheat. In this case, a buzzer will
sound, the system will be temporarily
canceled, and a message stating a mal-
function may be displayed on the multi-
information display. In this event, stop the
vehicle in a safe place until the message
goes off.
■ Sounds and vibrations caused by the
Crawl Control system
● A sound may be heard from the engine
compartment when the hybrid system is
started or just after the vehicle begins to
move. This sound does not indicate that a
malfunction has occurred in Crawl Con-
trol system.
● Either of the following conditions may
occur when the Crawl Control system is
operating. None of these are indicators
that a malfunction has occurred.
• Vibrations may be felt through the vehi-
cle body and steering.
• A motor sound may be heard after the
vehicle comes to a stop.
■ When there is a malfunction in the sys-
tem
Warning lights and/or warning messages
will turn on. (P.617, 623)
This function assists cornering perfor-
mance in accordance with steering
operation when driving through a tight
corner. It maintains vehicle speed
while driving and implements control
that improves turning performance
according to the driver’s steering
wheel operation, to reduce the number
of turns.
1 While Crawl Control is operating,
press the on Front Multi Oper-
ation Panel to display the off-road
driving information display screen.
(P.480)
2 Press the Turn Assist switch
The indicator light and Turn Assist
indicator on the meter will come on.
To turn the system off, press the switch
again.
1 While the Turn Assist function is
operating, press the on Front
Multi Operation Panel to display
the off-road driving information dis-
play screen. (P.480)
2 Press the Turn Assist switch
The indicator light on the Turn Assist
switch and Turn Assist indicator on the
meter will go off, and a message stating
that the Turn Assist function has been
Turn Assist function
Turning the Turn Assist function
on
Turning the Turn Assist function
off
To Next Page
Loading...
