482
5-1. Display
The time it takes to switch screen
displays when no operation is per-
formed can be set to either 20 sec-
onds, 1 minute or 5 minutes.
The screen operation sensitivity
can be set to either 1 (low), 2 (nor-
mal) or 3 (high).
Software information is displayed.
■ Operation condition
When the power switch is in ON.
■ Operation screen
● Touch the operation screen gently with
your fingers so that the screen is not
damaged.
● If the operation screen does not respond,
withdraw your hand from the screen
momentarily and then touch it again.
● When is displayed on the
screen, select to return to the
previous screen.
● In the following situations, the operation
screen may not respond or operate nor-
mally.
• When wearing gloves
• When operating the screen with your
nails
• When another finger or the palm is near
another switch
• When the screen is dirty or wet
• When a film is applied to the surface of
the operation screen
• When the surface of the operation
screen is coated
• When the vehicle is in an area where
strong electrical waves or noise are emit-
ted, such as near a television tower,
power plant, gasoline station, broadcast-
ing station, large display, airport, etc.
• When carrying a wireless device such as
a radio or cell phone
● If the operation screen is touched or cov-
ered by the following types of metallic
objects, the operation screen may not
respond or operate normally.
• A card that has metal on it, such as alumi-
num foil, etc.
• A pack of cigarettes containing alumi-
num foil
• A wallet or bag made of metal
•Coins
• A heating pad
• CDs, DVDs or other media
● The operation screen may respond when
wiping the operation screen for cleaning.
● If your hand is near the operation screen
when the power switch is turned to ACC
or ON, the operation screen may not
respond. If this occurs, withdraw your
hand from the operation screen, and then
turn the power switch to OFF and then to
ON.
■ LCD screen
● When the LCD screen is viewed at an
angle, it looks lighter or darker.
● When light from the sun or another
external light source strikes the screen,
the screen is difficult to see.
● When wearing sunglasses with polarized
lenses, the screen looks lighter or darker.
■ Open source software information
©1982-2013, QNX Software Systems
Limited. All rights reserved.
A
B
C
■ Use when driving
For safety reasons, drivers should avoid
performing operations as much as possi-
ble while driving. Performing operations
while driving may cause the driver to
mistakenly operate the steering wheel,
which may lead to an accident. Stop the
vehicle before using. Furthermore, avoid
looking at the screen as much as possible
while driving.
To Next Page
Loading...
