548
5-6. Using the other interior features
3 Within 1 minute of pressing the
HomeLink
®
button, after the
garage door operation has
stopped, press the “Learn” or
“Smart” button on the garage door
opener motor. Within 5 seconds of
the establishment of 2-way com-
munication with the garage door
opener, both garage door opera-
tion indicators in the vehicle will
flash rapidly (green) and the light
on the garage door opener motor
will blink twice, indicating that 2-
way communication is enabled.
■ Reprogramming a single
HomeLink
®
button
When the following procedure is per-
formed, buttons which already have
devices registered to them can be
overwritten:
1 Press and hold the desired
HomeLink
®
button.
2 When the HomeLink
®
indicator
starts flashing orange, release the
HomeLink
®
button and perform
“Programming HomeLink
®
” step 1
(it takes 20 seconds for the
HomeLink
®
indicator to start flash-
ing).
■ Before programming
● Install a new battery in the transmitter.
● The battery side of the transmitter must
be pointed away from the HomeLink
®
buttons.
Press the appropriate HomeLink
®
button. The HomeLink
®
indicator light
should turn on.
The status of the opening and closing
of a garage door is shown by the
garage door opener indicators.
Vehicles with inside rear view mir-
ror
Opening
Closing
Vehicles with Digital Rear-view
Mirror
Opening
Closing
This function is only available if the garage
door opener motor used is a compatible
device. (To check device compatibility,
Operating HomeLink
®
A
B
A
B
To Next Page
Loading...
