555
6-1. Maintenance and care
6
Maintenance and care
● Do not apply wax to the surfaces of the
lights.
Wax may cause damage to the lenses.
■ When using an automatic car wash
Set the wiper switch to off position.
If the wiper switch is in “AUTO”, the wip-
ers may operate and the wiper blades
may be damaged.
■ When using a high pressure car wash
● When washing the vehicle, do not
spray the camera or its surrounding
area directly with a high pressure
washer. Shock applied from high pres-
sure water may cause the device to not
operate normally.
● Do not spray water directly on the
radar which is equipped behind the
radar sensor cover. Otherwise it may
cause the device to be damaged.
● Do not bring the nozzle tip close to
boots (rubber or resin manufactured
cover), connectors or the following
parts.
The parts may be damaged if they
come into contact with high-pressure
water.
• Traction related parts
•Steering parts
•Suspension parts
•Brake parts
● Keep the cleaning nozzle at least 11.9
in. (30 cm) away from the vehicle
body. Otherwise resin section, such as
moldings and bumpers, may be
deformed and damaged. Also, do not
continuously hold the nozzle in the
same place.
● Do not spray the lower part of the
windshield continuously. If water
enters the air conditioning system
intake located near the lower part of
the windshield, the air conditioning
system may not operate correctly.
● Do not wash the underside of the vehi-
cle using a high pressure car washer.
To Next Page
Loading...
