56
1-2. Child safety
■ Child restraint LATCH anchors
5-passenger and 7-passenger
models
LATCH anchors are provided for the
second outboard seats. (Marks dis-
playing the location of the anchorages
are attached to the seats.)
4-passenger models
LATCH anchors are provided for the
each second seats. (Marks displaying
the location of the anchorages are
attached to the seats.)
■ When installing in the seats
Install the child restraint system in
accordance to the operation manual
enclosed with the child restraint sys-
tem.
1 Adjust the seatback angle to the
most upright position. When install-
ing a forward-facing child seat, if
there is a gap between the child
seat and the seatback, adjust the
seatback angle until good contact
is achieved.
2 If the head restraint interferes with
the child restraint system installa-
tion and the head restraint can be
removed, remove the head
restraint. Otherwise, put the head
● When installing a child restraint sys-
tem in the second center seat (if
equipped), adjust both seatbacks at
the same angle. Otherwise, the child
restraint system cannot be securely
restrained and this may cause death or
serious injuries in the event of sudden
braking, sudden swerving or an acci-
dent.
■ When installing a booster seat
To prevent the belt from going into ALR
lock mode, do not fully extend the shoul-
der belt. ALR mode causes the belt to
tighten only. This could cause injury or
discomfort to the child. (P.32)
■ Do not use a seat belt extender
If a seat belt extender is used when
installing a child restraint system, the seat
belt will not securely hold the child
restraint system, which could cause
death or serious injury to the child or
other passengers in the event of sudden
braking, sudden swerving or an accident.
Child restraint system fixed with
a child restraint LATCH anchor
To Next Page
Loading...
